7
V 05/13
Do not position the fan heater below a socket outlet.
Do not operate the appliance outdoors.
WARNING
:
do not use the fan heater with a controller or any other external device that activates the appliance
automatically, as there may be a risk of fire if the fan heater is covered or incorrectly positioned.
Upon initial start-up, the fan heater may emit a slight, harmless smell. This smell is a normal effect of the initial heating up
of the internal heating elements, and should not recur later on.
WARNING: DO NOT DEPEND ON THE ON/OFF BUTTON SWITCH AS THE SOLE MEANS OF DISCONNECTING
POWER. WHEN SERVICING OR MOVING THE FAN HEATER, ALWAYS UNPLUG THE POWER CORD.
A fan heater has hot and arcing or sparkling parts inside. It must not be used in potentially dangerous locations such as
flammable, explosive, chemical-laden or wet atmosphere.
Do not place the fan heater on soft surfaces, like a bed, where openings may become blocked. Always place the fan
heater on a stable, flat, level surface when operating, to avoid the chance of the fan heater overturning. Locate the power
cord so the fan heater or other objects are not resting on it.
Always unplug the fan heater when not in use.
In order to avoid accidents turn unit off if unattended.
In the event of any problems (abnormal noise or a strange smell) switch off the appliance immediately, do not
attempt to repair it and take it to your local after sales service.
DESCRIPTION OF PARTS
1. On/off and selection knob
2. Discharge grille
3. Air suction grille
4. Oscillation button
5. Base
6. Handle
HOW TO USE THE FAN HEATER
Position the unit on a flat, stable surface.
When you move the appliance, use the handle on the rear.
Connect the power cord to a suitable electric socket (220-240V~/50Hz).
Position the on/off and selection knob to “Comfort”
(2000 W), “Eco”
(1300 W) or Cold ventilation .
SWING button
When the appliance is operating, touch the button to make the appliance oscillate automatically, shifting the air flow from left
to right (Position I). Touch the button again to interrupt the oscillation. (Position 0).