Argo AGHP081PH, Руководство пользователя

Страница: 21 / 42

Operation Instructions
17
2.4.2 2-Way valve
[Operation Instructions]
At the commissioning parameter setting page, by touching “
Cool 2-Way valve ” or “ Heat 2-Way valve ”, the control
panel will access to the corresponding setting page.
[Notes]

Under “ Cool ”, or “ Cool + Hot water ” mode, “ Cool 2-Way valve ” will decide the status of the 2-way valve; while
under “ Heat ” or “ Heat + Hot water ”, “ Heat 2-Way valve ” will decide the status of the 2-way valve.

It will be memorized upon power failure.
2.4.3 Solar Setting
[Operation Instructions]
1. At the commissioning parameter setting page, by touching “
Solar setting ”, the control panel will access to its
submenu page.
2. At the submenu page, “ Solar setting ” can be set to “ With ” or “ Without ”.
3. At the submenu page, the “ Solar heater ” can be set to “ On ” or “ Off ”.
Solar Setting
[Notes]

This setting can be done no matter if the unit is turned on or off.

This setting is allowed only when the water tank is available. When the water tank is unavailable, this setting will
be reserved.

It will be memorized upon power failure.
2.4.4 Water Tank
[Operation Instructions]
At the commissioning parameter setting page, by touching “
Water tank ”, the control panel will access to the
corresponding setting page, where “Water tank” can be set to “ With ” or “ Without ”.
[Notes]

This setting will be memorized upon power failure.

This setting will become valid only when the unit is turned off.
2.4.5 Thermostat
[Operation Instructions]
1. At the commissioning parameter setting page, by touching “
Thermostat” , the control panel will access to the
corresponding setting page.
2. At the “ Thermostat” setting page, it can be set to “ Air ”, “ Without ” or “ Air + hot water ”. When it is set to “ Air ” or
“ Air + hot water” , the unit will run based on the mode set by the thermostat; when it is set to “ Without ”, the unit will run
based on the mode set by the control panel.