ARGENT BATH FILLERS
1. INSPECT ALL PARTS PRIOR TO INSTALLATION FOR SUITABILITY AND/ OR DEFECTS
2. ANY SUSPECTED DEFECT SHOULD BE REPORTED AS SOON AS POSSIBLE
3. SHOULD ANY PRODUCT BE INSTALLED DESPITE A FAULT HAVING BEEN FOUND AND REPORTED, ARGENT WILL
NOT ACCEPT LIABILITY FOR THE COST OF LABOUR TO REMOVE AND INSTALL ANY REPLACEMENT PRODUCT/S
NOTES PRIOR TO INSTALLATION
Argent Bath Filler
Care & Installation Guide
Technical Hotline
Customer Central
1800 356 717
1300 364 748
www.argentaust.com.au
1. For new installations, install the rough in body in the designated place so that the base is 50-55mm below
the finished floor height. For retro fit installations, CHASE A CHANNEL IN THE FLOOR IN THE designated place
for the ROUGH IN base. (50-55mm depth) Ensure that the plastic cover is installed level to the finished floor
surface.
2. Connect the hot and cold water feed pipes using thread seal tape or equivalent. Red = Hot, Blue = Cold
3. Mark and secure the rough in body using all four fastening points, check that the rough in body is true and
level when tightening the bolts. Use shims to level if required.
4. Leave the plastic blanking plate in place for wet seal test.
5. Ensure there is a 95mm clearance hole around the rough in body while backfilling or tiling the floor
IN FLOOR BODY ROUGH IN
Please direct any feedback for this
product to Customer Central:
or call 1300 364 748
WMKT21008
3718
1. PLEASE ENSURE PIPEWORK IS FLUSHED CLEAR OF DEBRIS BEFORE
INSTALLING ROUGH IN BODY AND BATH FILLER.
2. INLET PRESSURE RANGE 100 – 500KPA
3. MAXIMUM HOT WATER TEMPERATURE 60 C
4. AS/NZS 3500 REQUIRES 500 KPA MAXIMUM OPERATING PRESSURE AT
ANY OUTLET WITHIN A BUILDING
5. HOT & COLD INLETS SHOULD HAVE EQUALISED WATER PRESSURES.
6. NOT SUITABLE TO BE INSTALLED WITH A GRAVITY FEED SYSTEM
NOTES FOR INSTALLATION
STEP1
STEPS 2&3
STEPS 4&5
