Page 4
5.
Press the “PRESET” button. (“c.h03.” will show in the display)
6.
Select the frequency “92.7” with the “CHANNEL UP” or “CHANNEL DOWN” buttons.
7.
Press the “PRESET” button. (“c.h04.” will show in the display)
8. Now, remove headphones from the plug and disconnect the power source from the back of the
receiver. The display will flash 5 times and then power down. The receiver will save all of the
presets and return itself to the user mode. Re-connect the power source and receivers
(complete with the three preset channels) are ready to use.
RESETTING THE RECEIVER:
The receiver is equipped with built-in, self-protection circuitry that will activate when receiving a variety of electrical or
environmental circumstances. This may cause the unit to lock-up or behave in an undesirable fashion. If this occurs,
reset the receiver by disconnecting it from its power source for one minute. This will restart the software and should
return the unit to normal operation. If problems persist, please contact your dealer or ARG for further assistance.
HEADPHONE JACK REPLACEMENT:
Because it is subject to heavy use, it is normal for the contacts in the headphone jack assembly to wear out over
time. The ARG FM receiver is equipped with a replaceable headphone jack module to address this wear without
replacing the entire unit. Under IDEAL conditions, the headphone jack is rated to last roughly 6,000 plug insertions
and removals (cycles). The headphone jack module can, in most cases, be changed without removing the receiver
unit from the cardio machine.
1. To remove the worn jack, lo
cate the “arrow” on the tab of the jack module located on the back side of
the receiver toward the bottom.
2.
Press on the “arrow” and slide the module in the direction of the “arrow”.
3. To install the new module, guide the grooves of the jack module into the tabs of
the receiver.
4. Push the module back into the receiver unit until it “clicks” into place.
