arf YAK55M 60CC, Инструкция по эксплуатации, Страница: 13 / 53

Items Required to Complete This Model:
•
50-70CC Gas engine and exhaust
•
Appropriate propeller for your Motor
•
All required engine and exhaust mounting
hardware
•
Ignition battery and switch
•
One quality throttle servo and appropriate
servo arm
•
4Pcs high quality metal gear servos or better
for the ailerons and elevators
•
Appropriate servo arms for the above
•
Servo wire extensions. Recommends two 24”,
One 18”, two 12” extensions
•
Two switches with charging jacks for the Rx
•
Two high quality Rx batteries of significant
capacity to power your choice of servos.
•
One Receiver of your choice
Shop Supplies/Tools
•
Covering Iron and heat gun
•
Assortment normal hobby tools such as
screwdrivers, hobby knife, drill and drill bits,
pliers, etc.
•
Thick and Thin CA adhesives
•
30 minute Epoxy
•
Isopropyl alcohol
•
Ruler or tape measure
•
Blue thread-lock or equivalent
Note: As with all kits, it’s a good idea to read all the instructions and study the parts before you begin
construction. Handle the parts of this kit with care so you do not damage any of the structure or covering.
Inspect all the parts for any shipping damage and report any issues to as soon as you can. Make sure you have
a flat and sturdy workbench and follow all safety advice for the tools and adhesives you plan to use.
AIRCRAFT COVERING
1. With all ARFs, varying temperatures and storage delays can cause covering material to loosen over time
and transportation. recommends lightly going over all the covering with a covering iron set at medium
temperatures. Be sure to use a soft cover over your iron so you do not scratch the covering surface.
Be sure you go over all seams and edges of the covering to assure it is secure to the airframe and other
covering. Be careful not to apply too much heat or you may cause bubbles or damage to the covering.