ARF CNC 6040, Руководство пользователя

Страница: 3 / 20

www.hl-yeah.com
3 / 20
Chapter 1 Introduction to CNC
Systems
This chapter introduces you to terminology used in the rest of this manual and
explains the purpose of the different components in a computer numerically
controlled (CNC) system. CNC machines are in many industries and becoming more
popular in manufacturing lines. The traditional machine types are Mills, Routers,
Lathes and Plasma cutters. The non traditional things that can be done with a CNC
system can be but not limited it laser measurement, pick and place, quilting,
assembly, laser cutting, rapid prototype, painting and so on.
Any machine tool is potentially dangerous. Computer controlled machines are
potentially more dangerous than manual ones because, for example, a computer is
quite prepared to rotate an 8" unbalanced cast iron four-jaw chuck at 3000 rpm, to
plunge a panel-fielding router cutter deep into a piece of oak, or to mill away the
clamps holding your work to the table.
If you are in any doubt, be sure to seek guidance from a professionally
qualified expert rather than risk injury to yourself or to others.
IP related to the software: the machine does not come with any software, operation
and use of this guide involved in the relevant software are from the Internet. All
copyrights belong to author, please go to the author's official website to download
the trial version or purchase authorization software. Any misuse of unauthorized
software, corresponding losses and legal issues are beared by the user.
When use desktop parallel port to connect CNC machine tool, you have to make sure
it was working at EPP mode. It can be setup in computer BIOS(refer to manufacturer
manual). Any after market available USB to the parallel port adapter can not make
the normal operation of the machine.
CNC engraving machine is to rely on the relevant software control work, the need for
proper software settings to normal operation. Without correct setting, machine
running can cause permanent damage.
Case 1, before Mach3 installment, Case 2, any sockets plug or disconnection, please
switch off control box. Machine tool work at 220V voltage, you must NOT open
housing in situation of power on.
During Machine Running, pleas wear Goggle and safety staffs to keep you safe.