-1-
FINAL TEST AND ADJUSTMENT OF THE SKY WALKER;
If the Sky Walker does not function correctly because of a gear problem, you should check the
mechanical test again on page 29. As a last option, disassemble the robot and build it again.
Study each step and all drawings very accurately. This is the best way to find the failure. When
there is an electronic problem, do the electronic test on page 11 again and use the trouble shoot
table on page 12.
Install the cover:
Finally, we will install the Sky Walker cover:
Before you fix the cover, be sure that the two
lamps are put into the front holes of the cover
correctly.
Install the cover to the chassis with the
2 pcs. M3 screws and nuts.
To install the cover you need;
To install the cover you need;
1 Pc. Cover
2 Pcs. M3x12 Screw
2 Pcs. M3 nut
1 Pcs. Robot Chassis
*)
*)
Switch on the robot, the lights start glowing
Switch on the robot, the lights start glowing
.
.
1) Clap in your hands.
1) Clap in your hands.
2) The Sky Walker
2) The Sky Walker
should walk forwards for a few
should walk forwards for a few
seconds and then stop automatically.
seconds and then stop automatically.
3) Shade the light sensor with your hand
3) Shade the light sensor with your hand
4) The Sky Walker
4) The Sky Walker
should walk forwards for a few
should walk forwards for a few
seconds and then stop automatically.
seconds and then stop automatically.
You can adjust the sound sensor sensitivity
with VR1.
You can adjust the light sensor sensitivity
with VR2.
First insert the two
lamps carefully into
the holes in the
Sky Walker cover!
