QUICK-START GUIDE
For more great Ares products, just visit: www.Ares-RC.com
For more great Ares products, just visit: www.Ares-RC.com
1
Remove the components from
the box and ensure you have the
following parts:
• Moulded float set
• red/blue decal sheet
• 2x piano wire spacer bars
• 2x piano wire struts
• 4x strut saddle clamps
• 1x saddle clamp screw set
• 1x water rudder set
• 1x 1.5mm Allen key.
This Quick Start guide is written for the Gamma V2 Float Set.
A full instruction manual is available to download from www.ares-rc.com
2
Unroll the self-adhesive sticker
sheet and carefully cut around the
edge of the trim stripes that match
your colour scheme. Apply the
stripe to the upper, outer edge of
each float, starting at the front and
carefully peeling the backing paper
away as you work your way back.
3
With the trim stripes correctly
applied each float will be a handed
mirror image of the other.
4
Slot one piano wire spacer bar
into position at the front of each
float, noting that the bar locates
in the forward slot of the two. The
remaining spacer bar locates in the
front slot of the rear float mount.
