4/8
LC9182SZG-DIM
S1
S2
S3
3. TouchLink to a Zigbee Lighting Device
Note:
1) If the remote control has already been used with the same lighting device before, TouchLink is not possible.
Reset both the remote control and lighting device to factory settings.
2) Directly TouchLink (both not added to a ZigBee network), each remote can link with 30 devices.
3) TouchLink after both added to a ZigBee network, each remote can link with max. 30 devices.
4) For Hue Bridge & Amazon Echo Plus, add remote and device to network first then TouchLink.
5) After TouchLink, the remote can control the linked lighting devices.
ZigBee Lighting Device
< 10cm
Step 1
: Set the zigbee lighting device to
start TouchLink commissioning, please
refer to its manual to learn how
.
LED indicator
Step 2
: Bring the remote within 10cm of
the lighting device
.
Step 3
: Short press any button to
choose a group to touchlink
.
Step 4
: Press and hold down until LED
indicator turns on
.
Step 5
:Immediately short press to
st
art
Touch
L
ink
c
ommissioning of the remote
.
LED indicator flashes fast for 3S, then
flash 6 times slowly to indicate successful
pairing to the device and the light
connected to the device will blink twice.
5. Factory Reset Manually
LED indicator
Step 2:
Immediately short press 5 times
continuously, indicator flashes 3 times
quickly to indicate successful reset.
Step 1:
Press and hold down until LED
indicator turns on.
Note: All configuration parameters
will be reset after the remote is reset
or removed from the network.
S1
S2
S3
4. Remove a Touchlink Paired ZigBee Lighting Device
ZigBee Lighting Device
< 10cm
Step 1
: Set the Touchlink paired zigbee
device to start TouchLink
commissioning, please refer to its
manual to learn how
.
LED indicator
Step 2
: Bring the remote within 10cm of
the lighting device
.
Step 3
: Short press the group button
that the device was linked to
.
Step 4
: Press and hold down until LED
indicator turns on
.
Step 5
: Immediately short press twice to
start TouchLink removing of the remote
.
LED indicator flashes fast for 3S, then
flash 6 times slowly to indicate
successful removing.
S1
S2
S3
After removal via TouchLink you can pair the same device again without restore the factory settings
of the remote control.