2/4
ING0007
TRANSPORT AND SHIPPING
Open the shipping carton and verify that all equip
ment necessary to operate the system has arrived
intact. Refer to the following packing list for
information on what items are included with your
model. If any equipment is missing or damaged,
contact your Arena Luci dealer immediately.
No. 1 LED inground ING0007
No. 1 Recessed box
No. 1 Torx screw driver
Before beginning initial setup of your LED
inground, make sure that there is no evident da
mage caused by transportation. In the event that
the unit’s housing is damaged, do not plug it in
and do not attempt to use it until after contacting
your Arena Luci dealer for assistance.
INSTALLING THE DEVICE
Before carrying out any operation, disconnect the
mains voltage from the system.
Remove the two Torx screws and slide the LED
head out of the recessed box.
The installation can be performed via the included
dedicated inground/recessed box. It must be
positioned so that when the installation is
complete, the unit is at the same level of ground
surface or floor: that is, the upper side of recessed
box should match the finished surface.
A
the inground box must be placed on a layer of
draining pebbles with a minimum thickness of
30cm in order to make easier the flow of rain
water and avoid the lift of moisture inside the box.
Keep in mind that at the end of the installation the
line joining the two fixing screws will be the
bisector between the four output windows. Orient
the inground box to direct the four light beams
where desired, otherwise when you will turn on
the LEDs the light beams will point in the wrong
direction.
B
the bottom layer of the installation should be ma
de with a material with proper draining capability.
C
the shunt from the 24 V DC line should be
performed using an IP68 rated cast resin joint.
D
the connection between the 24 V DC line and
the supply cable of the luminaire should be
performed through the recessed box, using an
IP68 rated power connection. Keep enough cable
length for maintenance purposes.
Complete the installation by closing the LED head on
top of the recessed box by tightening the two screws.
