Arecont Vision MegaView
®
2 Installation Manual
Install MegaView
®
2 Camera
Mounting the Camera:
1. Remove camera and hardware from the
box.
2. Use the mounting template (
Image 1-C
), to
prepare the mounting provisions for junction
box adapter installation.
3.
Attach provided Junction Box Adapter
(
Image 1-B
) to the wall using appropriate
hardware.
NOTE: Hardware, provided with the unit, is
only suitable for surfaces listed on page 3.
4.
Remove the conduit plug on Junction box
adapter and c
onnect ¾” NPT conduit pipe to
Junction Box Adapter shown in
Image 2
.
NOTE: Use silicon or water pipe seal tape
to make sure no water leakage between
conduit pipe and junction box adapter.
5.
Run Ethernet cable and other cables (if
necessary) through the Junction Box
Adapter and connect to Megaview
®
2 pigtail
cable as shown in
Image 8
.
6. Add provided rubber plug (
Image1-H
) on
the bracket to ensure a water tight
installation for outdoor applications as
shown in
Image 3.
7. Organize pigtail cable and attach
MegaView
®
2 camera to Junction Box
Adapter using provided screws (
Image 1-I
)
as shown in
Image 3-1 and Image 4
.
NOTE 1: Water damage from improper
installation is not covered by the warranty!
NOTE 2: Use of silicon on the RJ45 connector
without junction box adapter does not
guarantee a water resistant install.
Image 2
Image 3
Image 3-1
¾” NPT Pipe
