Arecont Vision MegaBall™ Installation Manual
8 | P a g e
24. To use the digital I/O, connect the digital I/O
to the pigtail cable connector as shown in
Image 2
.
Optional: Connecting Digital I/O and Audio Out:
NOTE: Table 1 shows the electrical
characteristics and Table 2 shows cable color
for digital I/O.
Electrical
Characteristics:
Min
Max
Camera
Input voltage (V)
(measured between
+ and – terminals)
ON
2.9
6.3
IR & DN
Versions
OFF
0
1.3
Output current (mA)
(measured between
+ and – terminals)
Applied Voltage
Rage: 0 - 80V
ON
-
50
DN
version
Only
OFF
-
0.1
Table 1
NOTE: Both the input and the output are electrically
isolated from the rest of the camera’s electrical
circuitry via general-purpose photo couplers. The
input is additionally protected with a serial 250 Ohm
resistor and a debouncing circuit. Duration of
any input signal should be at least 5ms to comply
with the requirements of the debouncing circuit.
Yellow
Digital IN +
Red
Digital IN –
Green
Digital OUT + / Audio Out +
Black
Digital OUT - / Audio Out -
NOTE: The Audio Out will be only available for
Megaball Audio models (-A)
Table 2
Camera Installation:
25. Install the AV100 application manager
Software. (
Image 19,
found on the CD).
26. Run the AV100 application manager by
double clicking on the icon shown below.
(
Image 20,
found on your desktop).
NOTE: you can download latest version
AV100 on website
http://www.arecontvision.com/softwares.php
Image 19 Image 20
27. Select “Run” next to “Setup Cameras” from
the AV100 application manager as shown in
Image 21
and wait for “Arecont Vision
Camera Installer” window to appear as shown
in
Image 22
.
Image 21
28. Click “Mode” tab to select desired install mode
on the Arecont Vision Camera Installer as
shown in
Image 22
.
