Original User Manual
–
A
REBO
S Spa Pool Copenhagen/ Bora Bora
13
4.4 Tightening Inflation Valve
•
Over time inflation valve may become loose. Use supplied valve wrench to tighten,
maintaining air seal.
•
Important:
Whilst using the wrench
–
Do not loosen valve as it will fail.
5. Operation
5.1 Setting the temperature
•
Press
SET TEMP/LOCK
and the numbers on display screen will start to flash.
Increase/decrease temperature by pressing
TEMP UP
or
TEMP DOWN
.
•
Choose desired temperature, press
SET TEMP/LOCK
again to confirm. Temperatures can be
set between the range of 5°C to 42°C. (see safety instructions for recommended operating
temperatures).
5.2 Inflate / Air jets
•
Press
INFLATE / AIR JETS
to start air jets
–
a red light will appear. Press again and air jets will
stop working
–
red light will go out.
•
Air jets stop automatically after 20 minutes. To reset, wait for 10 minutes and press
INFLATE
/ AIR JETS
. Air jets can be stopped / started any time during their 20-minute cycle.
•
Air Jets will stop after 20 minutes to avoid internal pump over-heating.
5.3 Heater
•
Press
HEATER
, red light will appear. Press
HEATER
again and heating system will stop, red
light will go out.
•
When heater system is on, filter system will switch on automatically to circulate water. When
temperature has reached 1°C above pre-set temperature, heating system will stop working,
but light will remain on. Filter pump will continue to operate even when heater is not
functioning.
•
When water falls 1°C below pre-set temperature, heating system will automatically heat
