User’s Manual –
A
REBO
S Plunge Router
11
4.6 Fitting/Removing the cutting tool
•
Warning!
Pull out the power plug first.
•
Caution! After working with the router, the cutting tool will remain very hot for a relatively
long time.
•
Caution!
Cutters are very sharp. Wear protective gloves at all times when handling cutting
tools.
•
Cutters with a shaft diameter of 6 mm and 8 mm may be fitted to this router. Most cutters
are available in both sizes.
•
You can use cutters made of the following materials:
- HSS: suitable for cutting softwood
- TCT: suitable for cutting hardwood, particle board and plastic.
•
Select the appropriate cutting tool for the job in hand.
•
When using the cutters for the first time: Remove the plastic packaging from the cutter
heads.
•
Clean the nut, clamp and shaft of the cutter before fitting it.
•
Press the spindle lock and allow the spindle to engage by turning it at the same time.
•
Undo the clamp nut using the open ended spanner.
•
If necessary, take the cutter you wish to remove out of the clamp.
•
Select the appropriate cutting tool for the job in hand.
•
Select the appropriate clamp for the cutter.
•
Now fit the clamp and nut into the cutting spindle.
•
Guide the cutter shaft into the clamp.
•
Press and hold the spindle lock.
•
Tighten the clamp nut using the open ended spanner.
•
The cutter must be inserted at least 20 mm into the clamp.
•
Before you start the electric router, check to ensure that the cutting tool is secure and runs
smoothly.
•
Warning!
Remove the setting and assembly tools before starting the machine.
5.
Operation
•
Never use a low quality or damaged cutter. Use only cutting tools with a shaft diameter of 6
mm or 8 mm. The cutters must also be designed for the appropriate idling speed.
•
Secure the workpiece so that it cannot be thrown through the air as you work on it. Use
clamps or a vise.
•
Always guide the power cable away from the back of the tool.
•
Never cut over metal parts, screws, nails etc.
5.1 ON/OFF switch
•
Press the safety lock-off and then press the ON/OFF switch to switch on the machine. Release
the ON/OFF switch to switch off the machine.
5.2 Speed control
•
The best speed depends on the material and the diameter of the cutter. Select a speed
between 11000 and 30000 rpm using the speed control switch.
