ARDES AR4P11D, Инструкция по эксплуатации

Страница: 12 / 16

Instructions for use
12
GB
1. Plug the appliance into the mains socket.
2. Turn on the main switch located in the back of the product (“I” position). The
appliance emits a “beep” (if “beep” sound is on) and stand-by icon flashes. If
the stand-by icon will not displayed, be sure that the appliance is on a horizontal
surface.
3. Press the On/Stand-by pushbutton to turn the appliance on. It begins heating the
room according to the last used settings.
4. Press the MODE pushbutton to select one of the below operating modes:
• Antifrost function (H icon): the appliance start to work around 10°C
• Fan function (I icon): the appliance start to work in cool air function
• Power 1 (G icon - 1 bar on in the display): the appliance work at the minimum
heating power level (800W)
• Power 2 (G icon - 2 bars on in the display): the appliance work at the medium
heating power level (1200W)
• Power 3 (G icon - 3 bars on in the display): the appliance work at the maximum
power level (2000W)
5. To distribute the air flow over a wider surface, press the swing pushbutton: it start
to swing from right to left and viceversa. To stop the appliance in the desired
position, simply press the oscillation pushbutton again.
6. To turn off the product press On-Stand-by pushbutton: the display will show a
countdown fro about 30 seconds. After 30 seconds the appliance will be in stand-
by mode.
7. To completely turn off the product the main switch must be in “0” position (off).
The product is equipped with adjustable thermostat by stopping the air flow as
soon as the desired ambient temperature is reached; hot air will start to flow again
when the ambient temperature drops. To select the desired temperature press “+”
or “-” pushbutton after set the power level (minimum, medium or maximum). The set
temperature will displayed on the display.
The set temperature can be displayed in either °C or °F; to set the unit of
measurement of temperature turn on the product, push and keep pushing “+”
pushbutton until the unit of measurement will flashing on the display. Push “+”
pushbutton to select the desired unit of measurement; wait a few seconds for the
setting to be memorised.
To activate ECO function press ECO pushbutton. The ECO icon will be displayed.
This function will compare the target temperature with the current ambient
temperature and it will automatically select the most appropriate heating power level
to guarantee an optimum comfort level while reducing the energy consumption.
(Attention: this function is available only if one power level 1, 2 or 3 is selected).
When the ECO function is on, ECO icon (A) is dispalyed and the appliance may
switch automatically to a lower or higher heating level even several time. The
corrisponding heating level is always shown on the display (G icon).
The appliance is equipped with 24 hours timer that allow to set the automatic start
or automatic off of the product. To set the automatic start: when the product is in
stand-by mode press TIMER pushbutton; TIMER icon (F) and the time remaining
before the appliance will be turned on blink on the display. To adjust the timer press
“+” or “-” pushbuttons then wait a few seconds for the setting to be memorised. On
display stand-by icon and timer icon blinking indicating that the timer for auto on
is set. When the programmed time is reached, the appliance is turned on with the