ARDEA ONE Atmos ultra CL200 38 Series, Инструкция по эксплуатации

Страница: 27 / 60

7
ENGLISH
(FIG.8)
(FIG.10)
(FIG.9)
(FIG.11)
To adjust the inclination, remove the fork
from the frame (FIG.7), then remove the
plates inside the structure of the frame (an
upper one and a lower one) and reinsert them
again in one of the four possible positions
(FIG.8-9-10-11). Reinsert the screws and
tighten them completely. Repeat the
operation, with the same measurements, on
the other front wheel.
WARNING!
Adjustment of the rear wheels
does not necessarily correspond
with movement of the front
wheels.
8.3.4 Single footplate
(FIG.12)
A
B
The height and inclination can be adjusted. To change the height, loosen
the through bolts on the frame. Reinsert the through bolts in the holes
at the desired height and tighten them completely (FIG.12-A). To adjust
the inclination, loosen the through bolts on the side of the footplate
(FIG.12-B), adjust the inclination to the desired position and tighten the
through bolts completely.
8.3.5 Brakes
Loosen the screws on the frame to adjust both depth and height.
8.3.6 Sides
(FIG.13)
Loosen the rear screws on the frame, loosen the front screw and
reinsert and tighten them completely based on the wheel
position. The sides must be positioned very close to the upper
edges of the wheel, as they serve as cushioning when the
wheelchair is being pushed upwards and when getting out of the
wheelchair. (FIG.13)