Arctiko LTF 225, Руководство по эксплуатации, Страница: 5 / 20

Installing the Freezer
1. Connect the plug from the unit to power. If the electrical connection (the plug) has to be changed,
always let an authorised electrician install the freezer (read the operation instructions).
2. The freezer should be located in a dry, cool place, out of direct sunlight. The freezer gives
off a great deal of heat when in operation. If the ambient temperature is too high, there is a risk that
the freezer will not operate correctly. It is recommended that the room be ventilated, so that the room
temperature does not exceed 30°Celsius at most. Class N.
3. Place the freezer on a solid and flat substrate. This will eliminate any vibration and irritating noise.
The freezer should be placed with at least 10 cm free to the sides, at least 15 cm free at the back,
and at least 100 cm free to the ceiling.
The installation should be fused with a 16 A fuse.
Before Commissioning
Clean the freezer both inside and out using a damp, wrung out cloth. Dry with a dry cloth.
The smell from the plastic parts in the freezer will disappear once the freezer has been cooled down.
Start Procedure
Put the plug in the socket. The freezer should run for at least 1 hours before the thermostat is changed.
(Stabilisation of the cooling system).
Caution!
Do not place bottles or boxes containing carbonic acid or chemical agents in the freezer.
Do not place inflammable liquids such as ethane, petrol or alcohol in the freezer. Risk of explosion!
No bottles or tins should be placed in the freezer, as they could explode and cause injury to personnel.
Always use thermal gloves when operating the freezer, to reduce the risk of frost-bite.
In the event of repair work or corrective action in the installation in the machine room,
the plug should always be removed! Repair work in the installation should be carried
out by an authorised electrician!
5