Arctica HEC906, Инструкция по эксплуатации, Страница: 5 / 9

To manually defrost the appliance:
1. Press and hold the DEFROST Button for 5 seconds.
2. The defrost cycle will start immediately and the Defrost LED
illuminates. The defrost will last a maximum of 30minutes.
Note: Starting a manual defrost also resets the automatic defrost
timer. The next automatic defrost will start six hours after the
manual defrost has finished.
3. Waste water is collected in the waste water tray.
Cleaning, Care& Maintenance
▲
Switch off and disconnect from the power supply before cleaning.
▲
Clean the interior of the appliance as often as possible.
▲
Do not use abrasive cleaning agents. These can leave harmful
residues.
▲
Clean the door seal with water only.
▲
Always wipe dry after cleaning.
▲
Do not allow water used in cleaning to run through the drain hole
into the evaporation pan.
▲
Take care when cleaning the rear of the appliance. Sharp edges can
cut.
▲
An agent or qualified technician must carry out repairs if required.
Cleaning the Condenser
Periodically cleaning the condenser can extend the life of the appliance.
We recommend that our agent or qualified technician clean the
condenser.
Troubleshooting
If your appliance develops a fault, please check the following table before making a call to your retailer.
Fault Probable Cause Action
The appliance is not
working
The unit is not switched on Check the unit is plugged in correctly and switched on
Plug and lead are damaged Call your agent or qualified Technician
Fuse in the plug has blown Replace the fuse
Power supply Check power supply
Internal wiring fault Call your agent or qualified Technician
The appliance turns on,
but the temperature is
too high/low
Too much ice on the evaporator Defrost the appliance
Condenser blocked with dust Call your agent or qualified Technician
Doors are not shut properly Check doors are shut and seals are not damaged
Appliance is located near a heat source or air flow Move the refrigerator to a more suitable location