Arctic AG10, Руководство пользователя

Страница: 8 / 24

Galvanized Gas Spreader
Page 8 www.arcticsnowplows.com
4) One on drive shaft coupling (Picture #13, Item #16 on Parts List)
5) One on split shaft coupling (Picture #5)
d) It is advisable to clean the air filter element. It can be easily washed out and
reused. At this time, it would be wise to check the drive belts for any appreciable
wear.
e) Apply dielectric grease in any electric connections periodically.
f) Inspect ratchet straps and tie down bolts.
Parts that are loose, broken, missing or plainly worn must be tightened or replaced
immediately.
g) After every use, empty and clean the hopper and wash off all external surfaces.
h) Tighten conveyor chain if required till the point when the center path of the chain
nearly touch the base, making an arc shaped path visible from side view, oil
conveyor chain, if needed for smooth movement of the load.
i) Remove any trapped or frozen substance that can cause obstruction to the
movement of conveyor chain.
Yearly Inspection
a) At the end of the operating season, the unit should be thoroughly cleaned and
lubricated (see daily inspection and lubrication). The conveyor chain (picture #10)
could be removed and stored in motor oil or grease. These preventative measures
should prevent premature rusting of the unit. Grease bolts on the chain tighteners
(picture #8).
b) At this time or before the start of the next season, it is wise to check all drive
components for appreciable wear. Any components which are questionable should be
replaced now. Check that all bolts are tight and ratchet straps are in good condition.
This short and simple check will avoid down time during the operating season.
c) Change the gear box oil (Picture #1).
d) Parts that are loose, broken, missing or plainly worn must be tightened or replaced
immediately