![Arctic Cat Pantera 3000 Скачать руководство пользователя страница 52](http://html.mh-extra.com/html/arctic-cat/pantera-3000/pantera-3000_operators-manual_2965358052.webp)
48
NOTE: Install the cap screw so the nut
will be located to the inside of the ski.
6. If using the existing nut, apply red Loc-
tite #271 to the threads of the cap
screw; then tighten the nut to 45 ft-lb.
7. Place new cotter pin into the ski cap
screw and spread the pin.
8. Repeat procedure for the other ski.
Rail Wear Strips
Arctic Cat recommends that the wear strips
be checked weekly and replaced as neces-
sary. Measure the wear strips at 25.4 cm
(10 in.) intervals. Wear strips must be 10.7
mm (0.42 in.) thick or thicker.
0743-189
If wear strip measurements are less than
specified, replacement of both wear strips
is necessary to prevent premature track
clip wear and possible track damage.
Take the snowmobile to an authorized
Arctic Cat Snowmobile dealer for this
service. This service is at the discretion
and expense of the snowmobile owner.
Each time a new set of wear strips are
installed, they should be tempered. Tem-
per the wear strips by driving the snow-
mobile for approximately a mile on a
hard pack trail; then immediately drive
into deep snow and allow the wear strips
to cool. Repeat the procedure (warming
up the wear strips; then cooling them
down) two or three times.
NOTE: The rail wear strips will wear
rapidly if the snowmobile is operated
on terrain on which the snow cover is
minimal. Loose snow is required to
cool and lubricate the wear strips and
prevent accelerated wear.
Содержание Pantera 3000
Страница 7: ...3 Snowmobile Safety Rules...