70
ENGINE IDLE RPM
ADJUSTMENT
AF920
To properly adjust the idle, a tachome-
ter is necessary. If one is not available,
take the ATV to an authorized Arctic
Cat ATV dealer.
To adjust idle RPM:
1. Start the engine and warm it up to
normal operating temperature.
2. Turn the idle adjustment screw in
or out until the engine idles at
1250-1350 RPM.
THROTTLE CABLE
ADJUSTMENT
To adjust the throttle cable free-play:
KM111A
1. Slide the rubber boot away; then
loosen the jam nut (1) from the
throttle housing.
2. Turn the throttle cable adjuster (2)
until the throttle lever has proper
free-play of 3-5 mm (1/8 - 1/5 in.).
3. Tighten the jam nut (1) against the
throttle housing securely; then
slide the rubber boot over the
adjuster.
AIR FILTER (V-Belt
Housing) - Utility
The air filter in the V-belt housing
cooling inlet must be kept clean. If the
ATV is used under normal conditions,
service the filter at the intervals speci-
fied. If operated in dusty, wet, or
muddy conditions, inspect and service
the filter more frequently. Use the fol-
lowing procedure to remove the filter
and inspect and/or clean it.
1. Remove the center cover from
between the front fenders; then
remove the two screws securing
the filter housing to the front
fender.
2. Remove the filter housing cover.
Tap the filter lightly to remove
dust and debris; then use com-
pressed air to thoroughly clean the
filter.
NOTE: Inspect the filter element.
If damaged or torn, it must be
replaced.
3. Install the filter housing cover onto
the filter housing.
4. Place the filter housing into posi-
tion on the front fender. Tighten
the two screws securely; then
place the center cover into position
between the front fenders. Tighten
the screws securely.
! WARNING
Adjust the idle to the correct RPM.
Make sure the engine is at normal
operating temperature before
adjusting the idle RPM.