Arctic Cat BEARCAT F5, Руководство оператора

Страница: 37 / 72

33
1. Open the left-side access panel; then
remove the fuel filter from the
bracket.
2. Remove the hose clamps and dis-
card; then slowly remove the fuel
hoses from the fuel filter. Dispose of
the excess fuel from the filter prop-
erly.
3. Inspect the fuel hoses thoroughly for
any signs of cracking, cuts, or wear
points.
4. Place the new hose clamps on the
fuel hoses; then with the fuel pump
inlet and outlet noted, connect the
fuel hoses to the fuel filter. Secure
with the hose clamps.
5. Secure the new fuel filter to the fuel
filter bracket; then start the engine
and inspect the fuel hoses and filter
for any signs of leaks.
Gasoline Additives
Fuel de-icer can be used for all models.
Also, periodic use of an injector cleaner
for the F5/1100 cc is recommended espe-
cially in the last tank of gasoline before
storage. Arctic Cat Fuel Stabilizer (p/n
0436-907) should also be added to the
last tank of gasoline before storage.
Fuel Pickup Valves
The F5/1100 cc are equipped with fuel
pickup valves in the gas tank. If ever there
is a restricted fuel flow and a pickup valve
is suspected, take the snowmobile to an
authorized Arctic Cat Snowmobile dealer
for this service. If not under warranty, this
service is at the discretion and expense of
the snowmobile owner.
Checking Engine Oil
Level (1100 cc)
1. Park the snowmobile on a level sur-
face; then start the engine and allow
it to warm up for 5-10 minutes, or if
the snowmobile was operated, allow
the engine to idle for approximately
30 seconds.

NOTE: The snowmobile must be
on a level surface for this procedure.
2. Shut the engine off; then remove the
oil level stick from the oil reservoir.
Wipe the stick clean.
ZJ002A
3. Insert the oil level stick into the oil
reservoir without threading it in and
remove. Read the oil level shown on
the stick. The oil level should be near
the middle of or on the high end of
the NORMAL range on the stick.
0741-490

NOTE: To attain an accurate oil
level reading, do not thread the stick
into the reservoir.
4. If steps 1-3 were followed and the
oil level is at or below the ADD
mark, add up to 1/2 qt of recom-
mended engine oil.
5. Repeat steps 3-4 until the oil level is
within the recommended range on
the oil level stick.
Changing Engine Oil/
Filter (1100 cc)

NOTE: Recycle or properly dis-
pose of the used engine oil.
CAUTION
Make sure the fuel filter is properly
seated into the holder located on the
tunnel behind the driven shaft.
! WARNING
Care must be taken if a hot drain plug
is removed by hand. Burning could
occur.