Arctic Cat ALTERRA 400, Руководство оператора

Страница: 44 / 80

42

NOTE: An E will be displayed if
there is an error caused by a no-
shift position signal.
9. High Beam Indicator - The High
Beam icon will appear only when the
headlights are on high beam.
10. 4WD Lock Indicator - Displays
LOCK when the front differential
lock has been engaged. Not utilized
on this model.
11. Speedometer - Indicates the approxi-
mate vehicle speed in miles per hour
(MPH) or kilometers per hour (km/h).

NOTE: To change mph/km/h dis-
play, press and release Mode But-
ton until the icon (MPH/km/h)
appears; then press the Set Button
to change the display.
Speedometer/LCD
Gauge (Digital) (500)
1. Clock/Engine Hour Meter - The
clock function indicates time in the
12-hour mode; the hour meter indi-
cates the total time the ATV has run
and cannot be reset to zero. To set
the clock, use the following proce-
dure.
EFI-011A
A. With the ignition switch ON,
press and release the Set Button
until the Clock is displayed;
then press and hold the Set But-
ton to activate the set mode
(clock display flashing).
B. Press and release the Set Button
to set minutes or the Mode But-
ton to set hours. Holding the
respective button down will
scroll the display.

NOTE: Clock memory power is sup-
plied through the 10-amp memory
fuse and verified during gauge
“power-up” and reset. In the event of
clock memory power failure (blown
fuse, etc.), the gauge will “power-up,”
reset, and shut down repeatedly until
clock memory power is restored.
Always check the 10-amp memory
fuse if this gauge condition is noted.

NOTE: The engine hour meter will
not activate until engine speed
exceeds 500 RPM.
2. Temperature Indicator - If the engine
coolant temperature exceeds the normal
operating range, the temperature icon
will begin flashing and the LCD will go
blank for 30 seconds; then the LCD
will return to normal. However, the
temperature icon will continue to flash.
3. Mode Button - Shifts the gauge
through two operating modes: speed-
ometer/tachometer and MPH/KPH.

NOTE: The Mode Button must be
pressed and released to shift
speedometer/tachometer modes. It
must be pressed and held to shift
MPH/KPH modes.
4. Set Button - The Set Button is used
to select the gauge display of clock,
hour meter, trip 1, trip 2, and odome-
ter. It is also used to activate the
clock set function and adjust the
minute display on the clock.
5. Fuel Level Indicator - Indicates
approximate amount of gasoline in
the gas tank.

NOTE: When the bottom seg-
ment flashes, approximately 3.5 L
(0.92 U.S. gal.) of gasoline remains
in the tank.
6. Oil Pressure Indicator - Will be dis-
played during self-test at start-up. It
will not be displayed during normal
operation as oil pressure is not moni-
tored on these models.
7. Odometer/Trip Meter - Odometer reg-
isters the total distance the vehicle has
traveled. The trip meter is resetable and
can be used to measure trip or trip legs.
The odometer cannot be reset.