79
PREPARATION AFTER STORAGE
Taking the ATV out of storage and cor-
rectly preparing it will assure many
miles and hours of trouble-free riding.
Arctic Cat recommends the following
procedure to prepare the ATV.
1. Clean the ATV thoroughly.
2. Clean the engine. Remove the
cloth from the exhaust system.
3. Check all control wires and cables
for signs of wear or fraying.
Replace if necessary.
4. Change the engine/transmission
oil and filter.
5. Check the coolant level and add
properly mixed coolant as neces-
sary.
6. Charge the battery; then install.
Connect the battery cables making
sure to connect the positive cable
first.
7. Check the entire brake systems
(fluid level, pads, etc.), all con-
trols, headlights, taillight, brake-
light, and headlight aim; adjust or
replace if necessary.
8. Check the tire pressure. Inflate to
recommended pressure as neces-
sary.
9. Tighten all nuts, bolts, cap screws,
and screws making sure all cali-
brated nuts, cap screws, and bolts
are tightened to specifications.
10. Make sure the steering moves
freely and does not bind.
11. Check the spark plug. Clean or
replace as necessary.
12. Follow the recommendations
found in the pre-start inspection.
CAUTION
Before installing the battery, make
sure the ignition switch is in the
OFF position.
Содержание 650 H1 2010
