Arctic Cat 2012 WildCat, Руководство оператора, Страница: 28 / 60

26
WC034C
Park Indicator Light
When the transmission is in park, the
indicator will illuminate on the speedom-
eter.
WC035A
Headlight Switch
WC085
Use the headlight switch to select the high
or low headlight beam. When the switch is
in the HI position, the high beam will illu-
minate. When the switch is in the LO
position, the low beam will illuminate.
Reverse Override Switch
This vehicle is equipped with a reverse
speed limiter system. When additional
RPM is needed in reverse, depress and
hold the override switch located on the
center console.

NOTE: The vehicle must be in 4WD
to activate the reverse override.
Accelerator Pedal
Press down on the pedal to increase
engine RPM and vehicle speed; release
the pedal to decrease engine RPM and
vehicle speed.

NOTE: This vehicle is equipped
with an RPM limiter that retards
ignition timing when maximum
RPM is approached. When the RPM
limiter is activated, it could be mis-
interpreted as a high-speed misfire.
Seat Latches
1. To remove the seat, lift up on the
latch release (located at the rear of the
seat); then raise the rear of the seat
and tilt it forward.
WC017A
2. To lock the seat into position, place
the front of the seat into the seat
retainers and push down firmly on the
rear of seat. The seat should automat-
ically lock into position.
! WARNING
The seat belt indicator is only a
reminder and automatically extin-
guishes after 8-10 seconds. It does
not indicate that seat belts are prop-
erly secured. It is the operator’s
responsibility to ensure all vehicle
occupants are properly seated with
seat belts secure and doors are prop-
erly latched. Serious injury or death
could occur as a result of falling out-
side a moving vehicle.
! WARNING
Never activate the override switch
while the throttle is open as a loss of
control could result.