There are two ways to remove collected water:
1. Use the bucket
When the unit is off and the bucket is full, the unit will beep 8 times, the
bucket full indicator light will
fl
ash, and the digital display shows P2.
When the unit is on and the bucket is full, the compressor turns off and
the fan turns off after drying the water off the condenser for 30 seconds.
The unit will then beep 8 times and the bucket full indicator light will
fl
ash, and the digital display shows P2.
To empty the full bucket, slowly pull out the bucket. Grip the left and
right handles securely, and carefully pull it straight out so water does
not spill. Do not put the tank on the
fl
oor because the bottom of the
bucket is uneven. Otherwise the bucket will fall and cause water to spill.
Discard the water and return the bucket to the unit. The bucket must
be placed and properly positioned for the dehumidi
fi
er to operate. The
machine will restart when the bucket is restored in its correct position.
Note: When you remove the bucket, do not touch any parts inside of
the unit. Doing so may damage the product. Be sure to push the bucket
gently all the way into the unit. Banging the bucket against anything or
failing to push it in securely may cause the unit not to operate. When
you remove the bucket, if there is some water inside the unit you must
dry it. The power button fl ashes when the bucket is not properly in
place.
2. Continuous
draining:
Water can be automatically emptied into a
fl
oor drain by attaching the
unit to an ID
≥
5/16” water hose with a OD:M=1 male threaded end (not
included, a standard garden hose works well).
Install the drain hose
onto the adaptor A (see B1). The adaptor is found in the accessory bag
located in the bucket. Remove the plastic cover from the back drain
outlet of the unit and set it aside. Remove the bucket, then insert the
drain hose through the drain outlet of the unit and securely press it into
the connector on the front of the unit (see B2 and B3).
Tighten the adaptor A and the unit by using two screws (found in the
Owner’s manual bag). Install the female threaded end of the water hose
into the adaptor A (see B4), then lead the water hose to the
fl
oor drain
or a suitable drainage facility. Make sure the hose is secure so there are
no leaks. Direct the hose toward the drain, making sure that there are
no kinks that will stop the water from
fl
owing. Place the end of the hose
into the drain and make sure the end of the hose is level or declining to
let the water
fl
ow smoothly. Place the bucket back in the unit and make
sure that it is located correctly. Select the desired humidity setting and
fan speed on the unit for continuous draining to start.
Accessories (for continuous drain):
Drain hose (1 pc) Adaptor A (1 pc) Screw (2 pc)
Operating Instructions
REMOVING COLLECTED WATER
A1.
Pull the bucket out a little
A2.
Hold both sides of the bucket with
even strength, and pull it out from the
unit. Pour the water out.
B1.
B2.
B3.
B4.
Drain hose
Adaptor A
Plastic cover
Drain hose
subassembly
Connector
Drain hose
Water hose
Female thread
end
