10
B4600 series Battery-Powered Tools (HK1189)
Troubleshooting
Kits and Accessories
BATTERY (QUICK-CHANGE):
18.0 V: B-18
B4600 NOSE PIECES:
99-3303L
99-3305L
99-3201L
BATTERY CHARGER:
100 V-240 V~/50-60 Hz: CH-18-120-240
B4600S NOSE PIECES:
99-2701W
99-2707W
99-2725U
99-2731U
99-2737U
99-2782
1. Tool fails to operate when trigger is pressed:
a. Battery is loose or not connected.
b. Battery is depleted.
2. Pintail stripped and/or swaged collar not ejected
from anvil:
a. Check for broken or worn jaws in nose assembly.
b. Check for worn anvil.
3. Tool overloaded (LED flashes slowly - 1Hz):
a. Check that fastener installation requirements are
within the tool’s work capacity (see page 9).
4. Tool will not return collet to forward position:
a. Check that there is no blockage in the anvil housing
(see page 9).
Always check the simplest possible cause of a malfunction first. For example, a loose or disconnected trigger line. Then
proceed logically, eliminating each possible cause until the defective part is located. Where possible, substitute known good
parts for suspected defective parts. Use Trouble Shooting Chart as an aid for locating and correcting trouble.
Attaching and Removing Nose Assemblies
INSTALLING A NOSE
ASSEMBLY
1. Using a 1 inch wrench,
remove Retaining Nut and
Anvil Adapter.
2. Screw Collet onto Spindle
Extension and, using an 9/16
inch wrench to hold Spindle
Extension in place, tighten
Collet using an adjustable
wrench.
3. Slide Anvil Adapter over
Collet and tighten.
4. Slide Anvil into Anvil Holder,
and tighten Retaining Nut
using a 1 inch wrench.
NOTE:
NON-”L” series nose
assemblies can be used by
removing the Nose Spindle
Extension first using a 1/4 inch
hex key, and an adjustable
wrench for the Collet.
Do
not remove the tool Spindle
Extension.)
Anvil
Insert
Anvil
Holder
Collet
Chuck
Jaws
Follower
Spring
Cap
Anvil
Insert
Anvil
Holder
Collet
Chuck
Jaws
Follower
Spring
Cap
Nose Spindle
Extension
(must be
removed
for use with
this tool)
L SERIES
NON-L SERIES
Anvil
Assembly
Collet
Unitized
Jaws
Spindle
Extension
NON-L SERIES WITH
UNITIZED JAWS
