8 / 18 EN
Hair Styler / User Manual
3
Operation
3.1 Preparation
Check if the mains voltage on the type plate (on
the handle of the device) corresponds to your local
mains supply.
3.2 Operation
1. Thoroughly towel dry your hair after washing.
2. Plug the power cord
I
into the wall socket.
3. Turn on the appliance with the switch
E
and set
the required temperature level/blower level.
4. If necessary, interrupt heating by pressing and
holding down
D
the button (Cool Shot).
5. After rolling in the hair section allow the heat to
set for few seconds.
6. Unroll your hair section by press ing the roll-out
button
B
.
– This releases the brush and it can be rolled
out of the curled section.
Note
•
Cool Shot interrupts heating and provides a cool
air flow. This allows you to fix your hairstyle bet-
ter and more lastingly.
7. After use, switch off the appliance with
E
the
switch and pull the plug of the mains cable
I
out of the socket.
Note
•
Never wind the mains cable around the appli-
ance, because this can cause damage. Please
check the appliance and the cable regularly for
visible damage.
3.3 Settings
3.3.1 Temperature level/blower
level
E
–
0
: Off
–
1
: Gentle air flow and moderate temperature for
gently drying and styling
–
2
: Strong air flow, high temperature for quick drying
and styling
3.3.2 Cool shot
D
–
❄
: Interrupts heating and provides a cool air
flow
3.3.3 Changing the styling attach-
ments
1. Detach the attached styling attachment
A
by
pressing on the catch (on the back of the appli-
ance)
C
and turning the hot air brush slightly to
the right.
2. Place another styling attachment on so that the
recess and the catch
C
(on the back of the ap-
pliance) are in line and turn slightly to the left
until it clicks.
Notes
•
The size of curls depends on the diameter of the
styling attachment: see “Special features”.
•
All three thermo brushes have a roll out function.
