arcelik 2315 A+ D, Инструкция по эксплуатации

Страница: 8 / 16

Electric connection
Your appliance is intended to operate at a
single-phase voltage of 230V/50 Hz. Before
plugging in the appliance, please make sure
that the parameters of the mains in your
house (voltage, current type, frequency)
comply to the operation parameters of the
appliance.

The information concerning the supply
voltage and the absorbed power is given on
the marking label placed in the back side of
the appliance.

The electric installation must comply with
the law requirements.

The earthing of the appliance is
compulsory. The manufacturer has no
responsibility for any damage to persons,
animals or goods which may arise from
the failure to observe the specified
conditions.

The appliance is endowed with a supply
cord and a plug (European type, marked
10/16A) with double earthing contact for
safety. If the socket is not the same type with
the plug, please ask a specialised electrician
to change it.

Do not use extension pieces or multiple
adapters.

Please keep a distance of min. 25 cm from
any furniture „suspended” above the
appliance. This clearance will also be kept in
case of a niche or of another construction
element.

The appliance is not built to be included into
the furniture.

Please fit the supplied accessories.
3
EN
Instruction for use

If you do not use your appliance for a few
days, it is not advisable to switch it off. If you
do not use it for a longer period, please
proceed as follows:
- unplug the appliance;
- empty the appliance;
- defrost it and clean it;
- leave the door open to avoid the formation of
unpleasant smells.

If the supply cord is damaged, it must be
replaced by the manufacturer, its service
agent or similarly qualified persons in order to
avoid a hazard.

If your appliance has a lock, keep it locked
and store the key in a safe place, out of the
reach of children. If you are discarding an
appliance with lock, make sure that, is made
ineffective. This is very important so as to
avoid children being trapped inside, which
may cause their loss of life.
Setting up
This appliance was designed to operate at an
ambient temperature b10°C and
+40°C. If the ambient temperature is above
+40°C, inside the appliance the temperature
can increase.
Set up the appliance far from any source of
heat and fire. Placing it in a warm room, the
direct exposure to sunbeams or near a heat
source (heaters, cookers, ovens), will
increase the energy consumption and shorten
the product life.

Please observe the following minimun
distances:

100 cm from the cookers working with
coal or oil;

150 cm from the electric and gas
cookers.

Ensure the free circulation of the air around
the appliance, by observing the distances
shown in Item 2.
Assemble on the condenser (in the rear side)
the supplied spacers (Item 3).

Place the appliance in a perfectly even, dry
and well ventilated place.
Assemble the supplied accessories.