Tr
ou
bl
es
ho
ot
in
g
E-24
Problem
Check that...
There are no lights lit on the
unit
<
the rCube rear panel power switch is in the ‘on’ position.
The power light is flashing red
<
the rCube is in upgrade mode. Insert a USB flash drive with upgrade file to
update or turn the power off and back on to reset to normal.
My rCube is on and an iPod is
docked, it appears to be playing
but I can’t hear any sound
<
the source is set to play from iPod by pressing the ‘iPod’ button on the remote or
the source button on the top panel until the source LED lights green (indicting
iPod source chosen).
<
both volume LEDs are not lit. If they are, this indicates that sound is muted. Press
the ‘MUTE’ button on the remote or a volume control button to unmute the
sound.
The unit responds erratically or
not at all to the remote control
<
the rCube is powered on, if it is in standby mode press the
P
button on the
remote to turn it on.
<
there are fresh batteries in the remote.
<
there is a ‘line of sight’ (no obstruction) between the remote and the rCube’s front
panel IR receiving point.
Hum when playing the ‘AUX-
in’ Analogue input
<
all cables are making good connection. If necessary withdraw the cable from he
connector and plug it fully in again (turn the power off before doing this).
<
the connections inside the source cable connector are not broken or badly
soldered.
<
if the hum originates only when one particular source component connected,
check that the source is properly grounded. Check that any aerial cable is ground
isolated. Contact an installation contractor for assistance.
The iPod is playing a video and
I have connected a display to
one of the video outputs but my
images are not displayed.
<
all cables are making good connection. If necessary withdraw the cable from he
connector and plug it fully in again (turn the power off before doing this).
<
the display source is set to display the input the cable is plugged into.
The sound is thin and lacking
in bass.
<
the Bass button on the rear panel is pressed.
Deselect this button to add extra bass.
<
the rCube is not too far from a wall.
Move the rCube closer to a wall or a corner for more bass output.
The sound is boomy with too
much bass
<
the Bass button on the rear panel is not pressed.
Depress this button to reduce the bass output.
<
the rCube is too close to a wall or corner.
Move the rCube away from a wall or a corner for less bass output.
Содержание RCUBE
Страница 1: ...certified kleer iPod Speaker System ...