5692 FRESCA DRIVE, LA PALMA, CA 90623 | 800.585.5957 | ARCADIACONTRACT.COM
Step 3: Once back and seat cushions are removed, face the two seating units approximately 42.75” away
from each other (measurement is taken from the bottom front of both plinth bases). Align the wing
brackets on the seating units with the wing brackets on the back panel. Secure the seats to the back
panel by using (4) 5/16-18 x 2” hex bolts [C], two per seat from the inside of the seat. The bolts go
into pre-inserted t-nuts in the back panel (Figure C).
Step 4: Securing the unit using anchor bolts or sandbags is optional. Skip to Step 5 if neither is being utilized.
To secure the unit to the floor, first drill the floor using the predrilled holes as guides. Affix (4) 3/8 x 5”
anchor bolts [D], two per seating unit (Figure D). If using sandbags, simply place them inside the
seating units, two bags per side.
Step 5: To install the seats, tilt the seat slightly upward making sure the ¼-20 x 2” hex bolts underneath the
seat cushion slide into the notches. Push the seat cushion down until it is flat against the seating unit
(Figure E).
continued next page
FIGURE C
FIGURE D
FIGURE E
[C] 5/16-18 x 2” hex bolts, 4
seating units
dimension taken
from here
back panel
[D] 3/8 x 5” anchor bolt, 4
¼-20 x 2” hex bolt (pre-installed)
