Version 2.
ON/OFF function.
NOTE:
Learning mode lasts for 12 seconds; if no signal is given to the receiver then it will
automatically exit learning mode without pairing the device.
To exit learning mode manually, simply press the
‘Learn’
button again.
！
If, during learning mode the load does not flash to confirm, this means that the receiver’s memory
is
FULL
and no further remote control may be paired unless one of the existing remote control is
first unpaired (see below).
NOTE:
Learning mode lasts for 12 seconds; if no signal is given to the receiver then it will
automatically exit learning mode without pairing the device.
To exit learning mode manually, simply press the
‘Learn’
button again.
！
If, during learning mode the load does not flash to confirm, this means the receiver’s memory is
FULL
and no further remote control may be paired unless one of the existing remote control is first
unpaired (see below).
n-pairing:
Removing single device:
1.
With the receiver that you intent to un-pair press the
‘Learn’
button once (LED will flash), this
will now enter learning mode.
2.
On the remote control press the
‘OFF’
button; the load will flash twice to confirm that the remote
control is now unpaired.
Removing all devices: (applicable to PBR/PER/PCR series only)
1.
Plug the receiver(s) into wall socket (LED will slow flash for 5 secs), this will now enter learning
mode.
2.
On the remote control press the
‘G / OFF’
button; the load(s) will flash twice to confirm that
memories originally stored in the remote control is now deleted.
U
