Version 2.
aring:
Pairing using
LEARNING MODE
:
1.
First choose the desired receiver(s) that you wish to control.
2.
Press the
‘Learn’
button once (LED will flash), this will now enter learning mode.
3.
On the remote control press the
‘ON’
button intended to be paired; the load will flash twice to
confirm that the remote control is now paired.
NOTE:
Learning mode lasts for 12 seconds; if no signal is given to the receiver then it will
automatically exit learning mode without pairing the device.
To exit learning mode manually, simply press the
‘Learn’
button again.
！
If, during learning mode the load does not flash to confirm, this means that the receiver’s memory
is
FULL
and no further remote control may be paired unless one of the existing remote control is
first unpaired (see below).
nparing:
Removing single device:
1.
With the receiver that you intent to un-pair press the
‘Learn’
button once (LED will flash), this
will now enter learning mode.
2.
On the remote control press the
‘OFF’
button intended to be unpaired; the load will flash twice to
confirm that the remote control is now unpaired.
P
U
