Version 2.
2.
With a remote control press the
‘ON’
button intended to be paired; load(s) will flash twice to
confirm that the remote control is now paired.
NOTE:
Learning mode lasts for 12 seconds; if no signal is received from a remote control during
this time then the module will automatically exit learning mode without pairing the device.
To exit learning mode manually, simply press the
‘Learn’
button again.
！
If during learning mode the module does not react and LED on module continues to flash, this
means that the module’s memory is
FULL
and no further remote control may be paired unless one of
the existing remote control is first unpaired (see below).
Un-pairing Receiver
Removing single device:
1.
On the module press the
‘Learn’
button once (LED on module will flash), this will enter learning
mode.
2.
With a remote control press the
‘OFF’
button intended to be un-paired; load(s) will flash twice to
confirm that the remote control is un-paired.
