UNPACKING AND ASSEMBLY
Inspect to ensure that no damage has occurred to the
tool and accessories during transport. If damaged,
report to the retailer immediately.
Remove the auxiliary handle from the box and attach
to the tool. (Fig. A)
Ensure that the clamping screw (18) is always fully
tightened before use.
PRODUCT FEATURES AND LIST OF
COMPONENTS
ITEM
Features and components
1
Mini Carver/Mini Grinder Trade Body
2
Auxiliary handle
3
ON/OFF Switch
4
Speed control
5
Drive Lock button
6
Extension arm
7
Mini shaft
8
Bearings
9
Bearing cap
10
Pan screw 4g
11
Small Pulley
12
Large Pulley
13
Belt
14
Guard cover
15
Pan screw 6g
16
Mini Industrial Blade
1
17
Clamping Washer
18
Clamping screw M5
19
Dust extraction cover
20
Sanding Pad
21
Sandpaper
22
Clamping Bush
23
Countersunk screw
24
Diamond Cutting Disc
2
25
Grinding Wheel
2
1
Included with Mini Carver
2
Included with Mini Grinder Trade
PRODUCT FEATURES AND LIST OF
COMPONENTS
Fig. A, Fig. B, Fig. C
MOUNTING TOOLS AND ACCESSORIES
WARNING:
To reduce the risk of serious personal
injury, turn the tool off and disconnect from the
power source before making any adjustments or
removing/ installing tools or accessories.
1. REPLACING CARVING AND
GRINDING DISCS
Insert a flat screw driver into the mini shaft (7) to
prevent rotation, then remove the clamping screw (18)
using the Allen Key provided with the tool (Fig. D).
Replace the blade with other Arbortech recommended
product as shown on the following diagrams.
Place the new disc over the small pulley, ensuring it is
properly centered and seated flat against the pulley
face. Place the clamping washer (17) over the disc
then insert and tighten the clamping screw (18) in
order as shown (Fig. E). Ensure the marks on the disc
are visible and arrow of rotation is pointing in the same
direction as the arrow on the back of the guard.
WARNING:
Failure to properly mount the discs over
the pulley could result in serious injuries or damage
the tool.
2. MOUNTING THE SANDING PAD
Follow the steps to remove the disc prescribed above
(step 1).
First position the sand paper (21) over the sanding
pad (20)then insert countersunk screw (23) into the
clamping bush (22) and together insert them into the
sanding pad centre hole. Next insert the sanding pad
over the small pulley (11) (Fig. F) and tighten the screw
onto the mini shaft.
3. MOUNTING THE DUST EXTRACTION
To fit-on the dust extraction, first insert the front lugs
of the Dust Extraction Cover (19) under the Guard
Cover cut-outs, then push down the rear end to snap
the latches over the Extension Arm side lugs as shown
in Fig.G. Fit the vacuum cleaner hose into the Dust
extraction hole (Fig. H). Dust extraction fits hose size
Ø35mm.
To remove the Dust Extraction Cover pull the dust
extraction latch sideway from the extension arm and
then pull out in reverse direction.
WARNING:
• To reduce the risk of personal injury always use
dust extraction.
• Provide for sufficient dust extraction when cutting
masonry materials.
• The vacuum cleaner must be approved for
vacuuming masonry dust
• Wear a dust respirator .
• The machine may be used only for dry cutting/
grinding.
ENGLISH
ORIGINAL
English
5
