Arbor Technology SCP Cube, Руководство пользователя

Страница: 17 / 29

- 7 -
Installation & Configuration
The following is a depiction of some different states of the SCP Cube:
The SCP Cube is
connected to a power
source.
Charging is in process.
The power output mode
is 12V.
The SCP Cube is
disconnected from a
power source.
It's exporting power to
the connected device.
The power output mode
is 24V.
The SCP Cube is
connected to a power
source.
It's fully charged.
The power output mode
is 24V.
2.2 Connection
A. Wiring the Power Input and Power Output
1. Before wiring, make sure the power source is disconnected.
2. Find the terminal block in the accessory box.
3. Use the wire-stripping tool to strip a short insulation segment from the
output wires of the DC power source.
4. Identify the positive and negative feed positions for the terminal block
connection. See the symbols printed on the panel indicating the polarities
and power range in voltage.
5. Insert the exposed wires into the terminal block plugs. Only wires with
insulation should extend from the terminal block plugs. Note that the
polarities between the wires and the terminal block plugs must be positive
to positive and negative to negative.
6. Use a slotted screwdriver to tighten the captive screws. Plug the terminal
block firmly, which wired, into the receptacle on the rear panel.