Arbor Technology P0715, Быстрое руководство по установке

Страница: 10 / 19

10 P0715 Quick Installation
Connecting Peripherals
The user can use the I/O interfaces located at the backside of the chassis to
connect external peripheral devices, such as a mouse, a keyboard, a monitor,
serial devices or parallel printer etc. Before connection, make sure that the
computer and the peripheral devices are turned off.
Connecting an external CRT
P0715 has a 15-pin analog RGB interface connec-
tor located at the rear side of the chassis. As to
resolution, P0715 otputs 800 x 480 instead of 800
x 600, it won't display completely at first when
you connect the monitor.
External Serial Ports (COM1/2)
The P0715 logic board supports four onboard serial ports, all COM ports
supports RS-232.
The external COM1, COM2 are all D-SUB 9-pin
connectors. To connect any serial device, follow
the following instructions:
1. Turn off the Panel PC system and the serial
devices.
2. Attach the interface cable of the serial device to the 9-pin D-SUB serial
connector. Be sure to fasten the retaining screws.
3. Turn on the computer and the attached serial devices.
4. Refer to the serial device's manual for instruction to configure the operation
environment to recognize the new attached devices.
5. If the serial device needs specified IRQ or address, you may need to run the
CMOS setup to change the hardware device setup.
Speaker Jack
P0715 has one speaker jack.