Arbor Technology IOT-500, Руководство пользователя

Страница: 22 / 28

- 8 -
Installation
2.1 SIM Card Installation
To install a SIM card to the device, locate the SIM card slot on the side and
insert the card following the direction as shown below. Push the SIM card into
the card slot until it locks into place.
To remvoe the SIM card, just push the SIM card in to eject it from its slot.
The device requires a 12~24V DC power supply. A 2-pin terminal block
receptacle is located on the side of the device for DC power connection.
2.2 Power Connection
2.2.1 Using the DC Terminal Block Connector
The IOT-500 comes with one 2-pin DC terminal block connector to
connect power to DC power connector on the device. To use the
block connector:
1. Use a wire-stripping tool to strip both of the wires from the DC-input
power source. Expose the wire to the appropriate length for the DC power
connector.
2. Insert the wires into the DC power connector terminals and use a
screwdriver to tighten the two captive screws on the connector.
Make sure to match the pinouts as described in 2.4.1 PWPIN on page
10 .
3. Connect the DC terminal block connector to the power connector on the
IOT-500.