arboga BOP 312, Руководство пользователя

Страница: 13 / 34

13
4 KU 12-exhaust system
4.1 Assembling and mounting the KU 12-exhaust unit
The following description on assembling and mounting of the KU 12-exhaust unit.
The angle (A) (see
fig.: 4.1 ) is first mounted at the back of the EPB 312-machine
and then as shown on the KU 12-motor. Dismount the blind stopper at the back of
the EPB 312-machine and mount the connector (B). Dismount the switch on the
EPB 312-machine without unscrewing the cables. Lead the cable (C) through the
connector (B) and mount the protection hose (D) to the connector (B). Mount the
cables from the KU 12-exhaust unit on the switch (see the wiring diagram). Mount
the switch again. Dismount the blind stoppers on the cover or the belt arm and
instead mount the lid (E) with the outlet. Also remember to mount the cork
washers (F). To the fit the suction hoses (G) and mount these with the straps (H).
The KU 12-exhaust unit must before use be mounted with suction hoses on the
outlet (I), which then is connected to the central exhaust unit. If the central
exhaust unit is not equipped with a cyclone, the exhaust from the KU 12-exhaust
unit must be connected to a cyclone which then is connected to the central
exhaust. If there is no central exhaust you have to mount dust bags (J) on the
outlet (I).
In case the KU 12-exhaust unit is mounted on a EP 312 double grinder the cast
pipe bends (K) can be used for mounting the KU 12-exhaust unit to the grinding
machine so that the angle (A) and the suction hoses (G) with accessories can be
left out.
Fig.: 4.1
4.2 Maintenance of the KU 12-exhaust unit
Nothing on the KU 12-exhaust unit needs maintenance besides it is necessary to
check if the suction hoses are in good condition and if the suction channels need
cleaning.