Model XT101A In-Car Transmitter User’s Guide
Arbitron Proprietary Information
Page 2 of 4
2006 Arbitron Inc
B.
C
ODE
C
ONFIGURATION
The transmitter emits one of four transmission codes based upon two on-board
switches. To configure the transmitter: 1) Open the XT101A case by removing the
two screws from the case and lifting the cover; 2) Remove and discard the
protective film from the switch bank; and 3) Slide the two switch actuators as shown
to select the respective PPM RF codes. See Figure 2 below.
SW1
Code = 0x638
SW1
Code = 0x71C
SW1
Code = 0x0E3
SW1
Code = 0x1C7
SW1
Code = 0x638
SW1
SW1
Code = 0x638
SW1
Code = 0x71C
SW1
Code = 0x71C
SW1
Code = 0x0E3
SW1
Code = 0x0E3
SW1
Code = 0x1C7
SW1
Code = 0x1C7
Figure 2: Transmitter Code Settings
Note: The transmitter must be configured prior to battery installation.