User manual - SPOT 2.6
User manual - SPOT 2.6
06/2022
06/2022
DOP_1590_A
DOP_1590_A
8
9
The rear panel of the SPOT 2.6 Touring is equipped with two NL4 connectors unlike the SPOT 2.6 Installation which is
equipped with cable gland connectors. The four pins of the two connectors are connected in parallel. The speakers occupy
points 1+/1-.
The IN connector is used to receive the audio signal. The LINK connector allows to redistribute it to another SPOT 2.6
connected in parallel.
SPOT 2.6 wiring in the table below :
NL4 / Gland connector
1+
1-
2+
2-
Rear panel connector
Hot (+)
Cold (-)
THRU
THRU
IN LINK
Wiring
1+ Hot
2+ THRU
1- Cold
2- THRU
2.2 Connections
APG speakers must be powered by APG or Powersoft amplifiers with the corresponding speaker preset. Failure to heed
this warning may cause damage to speaker components and the user experience will not be optimal. Refer to the amplifier
manual fot its connection to the speakers.
DA8
DA12
SPOT 2.6 Touring / 4 ohms
8
8
SPOT 2.6 Touring / 16 ohms
8
16
SPOT 2.6 Installation / 16 ohms
8
16
In order to maintain sound quality, the wiring will be carried out with flexible deoxyged-copper speaker cable with a minimum
2.5mm2 section for lengths of up to 70m maximum for one speaker per channel.
Section recommandé [mm
2
]
Longueur maximum recommandé [m]
SPOT 2.6 Touring / 4 ohms
2.5mm
2
15m
SPOT 2.6 Touring / 4 ohms x 2
2.5mm
2
5m
SPOT 2.6 Touring / 16 ohms
2.5mm
2
70m
SPOT 2.6 Touring / 16 ohms x 2
2.5mm
2
35m
SPOT 2.6 Installation / 16 ohms
2.5mm
2
70m
SPOT 2.6 Installation / 16 ohms x 2
2.5mm
2
35m
Table : Wiring of loudspeakers /
amplifiers
Table : Recommended cable section & length depending
on the configuration
2.3 Amplifiers
IN
LINK
Touring version
Installation version
Содержание APG SPOT 2.6
Страница 1: ...SPOT 2 6 User manual ...
