1. Introduction
The ARB Awning 2500 has has been designed to fit most roof rack and roof bar systems,
horse floats, camper trailers and many other applications. This versatile product will give you
many years of trouble free service providing you follow these simple mounting, operating
and care instructions.
Before mounting the ARB Awning 2500 to your vehicle a few items need to be
consideredred.
1. The ARB Awning 2500 is supplied with 6 - 6x20mm
stainless steel bolts and nylock nuts. Where the mounting
is directly to the side of a roof rack, these bolts are usually
all that is required.
However, if you are mounting the ARB Awning 2500 to a
set of roof bars or in conjunction with an ARB Touring
Rooftop tent you will need an optional set of stainless
steel awning L brackets.
2. The ARB Awning 2500 needs to be mounted at a
suitable height so that the doors of the vehicle can be
opened without snagging the bottom of the awning.
3. The ARB Awning 2500 should be attached along it’s length at two points but preferrably
three points. Ensure that the unsecured length at each end of the awning does not exceed
700mm.
4. The ARB Awning 2500 should be attached using no less than 4 (6x20mm) nuts and bolts.
Note: 6 nuts and bolts supplied, using 6 is preferable.
5. The mounting extrusion at the back of the ARB Awning
2500 will hold the head of the 6x20mm bolts captive. The
bolts can be positioned anywhere along the length of the
awning to correspond to the most appropriate mounting
points.
PAGE 1
