1 Introduction
4
IMPORTANT:
To assure the highest level of planning and reliability goes into this installation,
please read this guide in its entirety before attempting any modifications to the vehicle.
1.1 Pre-Installation Preparation
Although your
ARB Air Compressor Bracket
comes complete with all the step by step
instructions you will need to install it, ARB recommends that you have your ARB Air
Compressor installed by a trained professional. Many ARB distributors around the world
have been fully instructed in
Air Compressor
installations by ARB, and have gained a wealth
of experience and skill from years of performing similar installations.
Make sure your
Air Compressor Bracket
kit is the correct model for your application and that
it contains all of the parts listed in section 1.3 below. Also, be sure you have appropriately
equipped yourself with all the necessary tools, parts, materials and knowledge to complete
this installation and minimize vehicle down time (see section 1.4
Tool-Kit Recommendations
).
Please refer to your ARB Compressor and Air Locker Operating & Service Manuals for
information on operating, servicing, driving technique, or trouble shooting your ARB Air
Locker(s) if installed.
HINT:
Place a mark inside each of the
symbols as you complete each step.
It is very important NOT to miss any of the steps!
1.2 Description
The 3540320 Ford Ranger Dual Cab Compressor Bracket kit enables the installation of a
CKSA or CKMA with optional Air Locker Solenoids, Quick Connect Coupling, Switch and
ARB LINX PRV behind the rear seat of the vehicle.
1.3 Kit Contents
➢
1 x 3752899 BRACKET COMPRESSOR MOUNT
➢
2 x 3752900 BRACKET COMPRESSOR MOUNT BASE
➢
1 x 3752901 COMPRESSOR SWITCH MOUNT PLATE
➢
1 x 6177573 F/KIT BAG 3540320
o
4x 180302 CABLE TIE
o
16x 4584378 - WASHER FLAT M6x16x1.2
o
1x 5811042 - NUT, MACHINED
o
1x 6151046 - WASHER FLAT 6MM
o
2x 6151173 - NUT FLANGE M6
o
10x 6151213 - BOLT HEX HEAD M6x1.0x20
o
1x 6151228 - BOLT HEX HEAD M6x1.0x30
o
4x 6151261 - NUT U M6x1.0
o
6x 6151278 - NUTSERT M6
o
4x 6151402 - BOLT HEX HEAD M6x1.0x16
