- 8 -
QR code
Image sensor 752*480 CMOS
illumination
Red Light LED 625±10nm
identification
code system
2Dbarcode PDF417, Data Matrix, QR Code
；
1Dbarcode UPC/EAN,Code39,Code128,code93
；
Recognition
view
Revolve 360*, i50*,def50*
Second
generation
ID card
technical
standard
Meet the standard of ISO/IEC 14443 type B, The
General Technique Requirements of GA450-2003
Desktop Resident Identity Card Reader and the
first revision list of The General Technique
Requirements of the 1GA450-2003 Desktop
Resident Identity Card Reader(draft).
Reading time
<3s
Reading
distance
0
～
3cm
Working rate
13.56MHz±7kHz
6. About the Battery
High-performance 6000mAh Li-polymer battery is installed in the terminal.
(1) Battery Life
：
Up to 8 hours for continuous work, standby for a week.
(2) Charging Method
：
Please charge your battery on time when the system warns. A full charge to 100% is
necessary.
(3) Time for Charging
：
A standard 6000mAh battery charge takes about 8-10 hours.
(4) Operating Notice
a). The standby time is measured in an actual environment, but the specific standby time
may vary in different areas. This is due to various factors.
b). A rechargeable battery for the device can charge and discharge hundreds of times, but it
will eventually wear out. When standby times are noticeably shorter than normal,
replace the original battery.
c). Disconnect the device and unplug charger after use.
d). Enter system hibernation if no intend to use battery for long period. Battery should be
kept in dry environment with full charge. Charge and discharge once every 3 to 6
months.
e). Use designated battery for replacement.
