Arai Regent-X, Руководство по эксплуатации

Страница: 10 / 20

10
English
Regent-X
To replace, position the shield on the base plate so that the lower part of
the sliding slot of the shield is over the spring clip of the base plate and the
brass stud is in the red hole of the base plate ⑦ . Press the shield onto the
spring clip, and then fully raise the shield until the brass stud falls into the
sliding slot of the base plate ⑧ & ⑨ . Position top hook on the backside
of the side pod into the top tab of base plate ⑩ , align the side pod with the
recess of the helmet shell and push the lower part of the side pod down
firmly until it clicks into place and is fully captured by the base plate ⑪ .
Repeat for the other side. Work the shield up and down to confirm proper
operation ⑫.
.
TO REMOVE/REPLACE BASE PLATE
To remove, first remove the shield. Remove two screws from each base plate
with a flat blade screwdriver or a coin
①
. Remove plates from helmet shell.
Note the right and left base plate for proper reinstallation.
To replace, place base plate over the threaded screw receptacles in the helmet.
Install the two screws through each base plate into the helmet finger tight
②
,
do not fully tighten. Install shield, lower the shield to fully closed position and
press the front center of the shield to bring it against the eyeport trim. While
still pushing on the shield to keep a tight seal against the eyeport trim, tighten
the base plate screws
③
– but be careful not to overtighten, as the screws
may break. It may be necessary to do one side at a time, with a smoothing
pressure from the shield center toward each base plate and tightening one and
then the other for best results.
⑨ ⑦ ⑧
⑫ ⑪ ⑩
①
②
③