ARAG Bravo 400 S LT Series, Использование и обслуживание

Страница: 50 / 84

50
Exit the function
or data change
Confirm access
or data change
Scroll
(LEFT /
RIGHT) Delete
selected
character Data
decrease
of data Scroll
(UP /
DOWN) Enter
selected
character
Par.
8.4
12.5 Spraying a field
Let us assume we want to spray a field
along parallel lines, but only once the
edges of the field have been sprayed.
Fig. 113
• Go to the beginning of the field to be sprayed.
• Switch the monitor on (par 8.2).
After self-diagnosis, the monitor displays screen
"Home" (Fig. 113).
• Begin a new spraying, using the function
F3
New job (par. 14.3).
• Enter spraying settings.
SPRAYING SETTINGS
Fig. 114
Fig. 115
Target rate
- Set the spray rate value for the spraying (Fig. 115).
Press
OK
to confirm the value.
Fig. 116
Fig. 117
Selected nozzle
- Select the nozzle among the ones on the list (Fig. 117).
With this data you indicate the type of nozzle installed on the boom
spraying points.
- Press
OK
to confirm.
Fig. 118
Fig. 119
Row width
- Set the value of the inter-row width (Fig. 119).
Press
OK
to confirm the value.
Fig. 120
Fig. 121
Select variable rate source
If there is at least one map (on the internal memory), you can select
a prescription map for the spraying.
According to the position detected by the GPS receiver, the monitor
will use the appropriate spray rate for the area that is being sprayed
(par. 13.3 Importing and using a prescription map).
- Select a map from the list (Fig. 121).
- Press
OK
to confirm.
Fig. 122
Fig. 123
Job Start
- Select and press
OK
to switch to guidance.
USE
CONTINUES > > >