BK767
Page 5
Garden Heater User Guide
3. Preparation For Use —
Locate a suitable placement for the heater, taking in mind the location of combustible
materials and level ground requirements. Moving of the heater is best done using a
sack truck, with an additional person steading and guiding the front.
Remove the outer cardboard packaging and internal plastic bag. See section on
recycling.
Inside the internal storage compartment, there are 4 no. temporary screws holding
the appliance to the base packaging pallet, these will need to be removed and the
heater carefully moved onto the ground. Again the wooden pallet can be recycled.
At each of the 4x corners, there are height adjustment screws, these have swivelling
heads and can be adjusted accordingly to suit the ground conditions. Use a 12mm
open ended spanner (See Fig. 1).
The door can then be opened with a suitable metal rod or screwdriver inserted into
the threaded handle boss. Rotate boss clockwise to open.
Locate the tapered fire door handle and screw this into the threaded section of the
door boss (See Fig. 2).
Position the 4x vermiculite liners into the firebox, note the 2x shaped ones are fitted
at the sides and the rectangular ones to the rear of the fire box (See Fig. 3).
Next slot the 1metre length of 5” (127mm) flue pipe into the connector. Ensure this is
vertical (See Fig.4).
Finally, place the flue cover on top of the flue pipe. This can be rotated through 360
degrees, so can be adjusted to suit the prevailing wind
conditions.
Remove
Packing
Screws
Fig. 1
Fig. 4
Fig. 2
Fig. 3
