AR 10044005, Руководство по эксплуатации и обслуживанию

Страница: 42 / 72

Model 5000A225A
28 Rev B
2.4.2.6.9 State
Query to find the state of the Model 5000A225A.
Syntax: STATE?
Parameters: None
Response Format: STATE=<space>xyza<LF>
Where: x, y, z , and a are each an ASCII character representing a hexadecimal character.
They can be 0 to 9 or A to F.
Each hexadecimal character represents a 4-bit binary number. This 4-bit number is a bit
pattern which contains information about the state of the Model 5000A225A. The
definitions of these bit positions can be found in the table below.
NOTE: Bits labeled NOT USED may be read as a bit state of 1 or 0
Table 2-6. Bit Position
BIT STATE
BIT
POSITION
BIT DESCRIPTION 0 1 NOTES:
x
0 PULSE STATUS OFF PULSE
1 (NOT USED)
2 (NOT USED)
3 REMOTE CONTROL DISABLED ENABLED
Response to key-switch
position
y
0 POWER STATUS OFF POWER ON
1 STANDBY STATUS OFF STANDBY Also known as RF OFF
2 OPERATE STATUS OFF OPERATE Also known as RF ON
3 FAULT STATUS OFF
FAULT
EXISTS
z
0 KEYLOCK INHIBIT OFF INHIBITED
Response to key-switch
position
1 ALC ALERT OK FOLD BACK ALC fold back indication
2 RF AUTO BIASING INACTIVE ACTIVE Biasing state
3 (NOT USED)
a
0 MODE MANUAL DISABLED ENABLED Also known as CW MODE
1 (NOT USED)
2 MODE ALC INTERNAL DISABLED ENABLED
3 (NOT USED)
Example:
To read the state, send the following query.
STATE?<LF>
Response: STATE=<space>8301<LF> (Remote Mode, Power On, RF OFF, and Manual Mode)