15
PROBLEM
CORRECTIVE ACTION
Unit will not turn on.
1. Make sure the power washer is in the “OFF” position. Plug in the electrical cord to a
grounded 120 volt outlet (no electrical extension cord should be used). If the electrical
cord will not plug into your outlet, your electrical outlet is not properly grounded and
should not be used. Use another electrical outlet.
2. If this did not correct the problem, try plugging into another electrical outlet and repeat
the above procedure. If it is still not working, call Customer Service at 1-866-235-5112.
The unit is running
but there is no water
ÁRZ
1. Power should NOT be turned on until water comes through the spray gun. Doing so will
damage the motor.
2. Check the water source.
3. Eject the nozzle from the lance to determine if clog is coming from the nozzle (If nozzle
is clogged, see nozzle cleaning instructions under “Cleaning nozzles”).
4. Take off the lance and just spray out of the spray gun. This will indicate if the problem is
with the lance.
&KHFN*DUGHQ+RVH$GDSWHUIRUORRVHFRQQHFWLRQDQGWKHÀOWHUIRUGHEULV
Why is water leaking
where the high
pressure hose
connects to the spray
gun?
1. Make sure there is an o-ring at the end of the metal tip of the high pressure hose. If
no o-ring is present, the connection between the hose and spray gun will leak. O-Ring
Replacement Kit (L) is included with purchase. Additional O-Ring Kits are available
online at www.arblueclean.com or call Customer Service at 1-866-235-5112 to place
an order.
The power washer
turns on for
2 seconds, shuts
off, and will not turn
back on. Do I have a
defective unit?
,WVRXQGVOLNH\RXUSRZHUZDVKHULVZRUNLQJMXVWÀQH:KHQWKHZDWHULVFRQQHFWHG
the accessories are assembled properly, and the power switch is turned on, the power
washer may turn on for 1 - 2 seconds to prime the pump. It automatically shuts off and
waits for the spray gun trigger to be pressed. When the trigger is pressed, water starts
ÁRZLQJWKURXJKWKHSXPS7KHZDWHUVHQVRULQWKHSXPS´VHQVHVµWKHPRYLQJZDWHU
and automatically turns the power washer on.
2. Turn the power switch to off, hold in the trigger on the spray gun, so that you have a
steady stream of water. While you are holding the trigger open on the spray gun, at the
same time, turn the power switch on.
TROUBLESHOOTING
If you have any questions regarding the product, please call customer service at 1-866-235-5112
