8
U
nPacking
& a
SSembLy
• After unpacking the BLUE CLEAN POWER WASHER, lay out parts and accessories. Familiarize
yourself with the parts in the package by comparing them to those listed on the “PACKAGE
CONTENTS” page.
• The BLUE CLEAN POWER WASHER requires some minor assembly. You’ll need a Phillips
screwdriver to install the high pressure hose hook and the nozzle tray.
NOTE:
Some parts may or may not be already assembled.
• High pressure hose is stored on the hose reel. With the front of the power washer facing towards
you, insert the un-threaded end of the high pressure hose into the square hole on the inner reel
and begin turning the handle away from you. When finished winding, push the handle in to lock it
in place.
NOTE:
The hose reel is only for storing the high pressure hose. The hose must be completely
removed from the hose reel each time you use the power washer.
• Slide the spray gun holder onto the left side of the washer when facing it. This does not require
any screws.
(Fig. 1)
• Slip tab into slot and screw the nozzle tray on the bottom portion of the unit.
(Fig. 2)
When
placing the gun with the lance attached the nozzle will rest in this tray.
• Easily remove the power cord from side of unit by swiveling the bottom cord hook to the right or
left until it faces up. The power cord then can be easily slid off of the side of the power washer
unit.
(Fig. 3)
• Swivel cord hook
back down when
ready to wrap the
cord back into
place for storage.
Fig. 2
Fig. 1
Fig. 3
